Rangemaster Professional + 100 - Final Checks; Fitting the Plinth; Customer Care

INSTALLATION
Check the appliance is electrically safe and gas sound when you have nished.
27
ArtNo.350-0012 - Securing the plinth
Final Checks
Hotplate Check
Check each burner in turn (refer to the ‘Hotplate Burners’
section at the front of the instructions).
Grill Check
Turn on the grill control and check that the grill heats up.
Oven Check
Set the clock as described earlier in the instructions, and then
turn on the ovens. Check that the oven fans start to turn and
that the ovens start to heat up.
Note: The oven light bulb is not included in the guarantee.
Turn o the oven.
Fitting the Plinth
Fitting the 1-piece Plinth (Classic & Professional+)
Loosen the three screws along the front bottom edge of the
cooker. Hook the central keyhole over the central screw. Twist
and t each end keyhole over their respective screws. Tighten
the xing screws (Fig. 8.14).
Fitting the 2-piece Plinth (Kitchener & Hi-LITE)
Fit the inner plinth to the bottom front of the cooker using
the 4 or 5 screws provided (Fig. 8.15).
Kitchener: Fit the outer plinth (2 screws, 1 each end) to the
inner plinth. The height of the outer plinth can be adjusted by
sliding it up or down via the slotted hole (Fig. 8.16).
Hi-LITE: Oer the keyhole slots on the outer plinth to the
location points on the inner plinth (Fig. 8.17)
When released the outer plinth should automatically adjust
to the oor height (Fig. 8.17).

WARNING: When moving the cooker ensure that the
outer plinth is removed. Failure to do so may result
in damage to plinth and oor.
Customer Care
Installer: Please complete your details in this guide, inform
the user how to operate the cooker and hand over the
instructions.
Thank you.
ArtNo.350-0010 - Fitting the plinth 1 (Kitchener)
ArtNo.350-0011 - Fitting the plinth 2 (Kitchener)
Outer plinth
Outer plinth xing screw
Inner plinth
Fig. 8.14
Fig. 8.15
Fig. 8.16
Fig. 8.17