Ransomes HR3300T - MAINTENANCE & LUBRICATION; MAINTENANCE & LUBRICATION CHART

SAFETY, OPERATORS & MAINTENANCE MANUAL
en-44
8 MAINTENANCE &
LUBRICATION
8.1 MAINTENANCE & LUBRICATION CHART
MAINTENANCE AND LUBRICATION CHART
Interval Item Section
First 50 hours
z Change Engine Oil
z Check Fan Belt Tension
8.2
8.3
Daily
10 hours
z Check Engine Oil Level.
z Check Safety Interlock System.
z Check Engine Coolant Level
z Check Hydraulic Fluid Level
z Check Tyre Pressure
z Check Rear Wheel Hub Nut Lock
z Check Engine Bay for Debris
8.2
7.2
8.4
8.5
4.2
8.11
8.12
Weekly
Every 50 hours
z Check for Loose Components.
z Check for Hydraulic Leaks.
z Check Fan Belt Tension.
z Check Air Filter Tell Tail Indicator*.
8.12
8.12
8.3
8.9
Every 250
hours
z Change Engine Oil & Oil Filter.
8.2
End of season
Every 1000
hours
z Check Battery Condition.
z Change Engine Oil & Oil Filter.
z Change Engine Air Filter Element*
z Replace Fuel Filters
z Change Hydraulic Oil & Filters
z Drain & Clean Fuel Tank
z Drain & Replace Engine Coolant
8.9
8.2
8.9
8.8
8.5
8.8
8.4
Lubricate all Grease fittings with Shell Darina R2 or equivalent Grease weekly
A = Lift Arm Pivot LH, B = Lift Arm Pivot RH, C = Stub Axle Pivot LH, D = Stub Axle Pivot RH, E =
Axle Pivot Centre, F = Steering Ram Ball Joint LH, G = Steering Ram Ball Joint RH (see diagram)
* Check more often in dirty conditions
IMPORTANT
Refer to Engine Manufacturers Manual for Additional Engine Maintenance Procedures
FLUID REQUIREMENTS
Quantity Type
A Engine Oil (with filter) 5.1 Litres 10W 30
B Hydraulic Oil (with filter) 42 litres Shell Tellus 46 (ISO VG 46)
Greenscare 46 (ISO 46) Bio Degradable Oil
C Radiator Coolant 5 litres 50% Anti-Freeze
D Fuel 51 litres No 2-D (ASTM D975) Diesel