Rapid Engineering 2000 Series

To Next Page

To Previous Page

SECTION 6: LIFTING AN A IR HANDLER

6.1.3 Lifting an Upright Air Handler

All air handlers are shipped in the horizontal position.

Prior to lifting an upright air handler, the following

steps must be performed (See Page 13, Figure 4):

Step 1: The air handler must be lifted using the two

lifting lugs on the top of the discharge end and the

two lifting lugs on the inlet end, using a spreader bar

across the long axis. Lift the air handler off the skid

and place it on a flat, clean, dry surface.

Step 2: Remove the lifting lugs on the inlet end of the

air handler and re-install hardware.

Step 3: Use all four lifting lugs on the discharge end

of the air handler to enable the air handler to be lifted

into the upright position.

Step 4: Lift the air handler into upright position.

Step 5: Next, refer to the applicable portions of Page

18, Section 9 for specific mounting instructions.

FIGURE 4: Lifting an Upright Air Handler

Step 1

Remove These

Lifting Lugs

Step 2

Step 3

Step 4

Spreader Bar

INLET

Rapid Engineering 2000 Series - Page 19