SERIES 2000 INSTALLATION, OPERATION AND SERVICE MANUAL
18
SECTION 9: UPRIGHT INSTALLATION
9.1 Upright Leg Assembly
It is recommended that two individuals are used for the assembly process.
Step 1:Assemble using the provided hardware: 3/8" bolts, nuts and lock washers. Begin assembly of the
legs with the top upside down on a flat surface. See Page 18, Figure 7.
FIGURE 7: Step 1
Crush Hazard
Use proper lifting
equipment and
practices.
Falling Hazard
Use proper safety
equipment and prac-
tices to avoid falling.
Severe Injury Hazard
Use proper lifting
practices and equip-
ment.
Equipment and
accessories are
heavy.
Cut/Pinch Hazard
Wear protective gear
during installation,
operation and
service.
Edges are sharp.
WARNING
Failure to follow these instructions can result in death, injury or property damage.
To Next Page
Loading...