SECTION 10: FILTER SECTION
23
10.2 Filter Section Installation - Horizontal Air
Handlers
10.2.1 Filter Section Installation
For installation directly onto the inlet of the air
handler, foam tape (provided by others) must be
applied to the filter section sides, top and bottom.
Attach the sides of the filter section to the factory
installed riv-nuts on the inlet of the air handler with
the supplied hardware. Additional TEK screws are to
be used along the top and flange of the filter section
to seal the bottom seam (minimum of one screw
every six inches, or more as necessary to provide a
tight seal with no gaps). Caulk (provided by others)
all seams between the filter section and air handler.
FIGURE 12: Filter Section Installation on Horizon-
tal Air Handler
10.3 Filter Section Installation - Upright Air
Handlers
10.3.1 Filter Section Installation
To install a filter section on an upright air handler that
is mounted on legs, the filter section must be
installed in the leg assembly prior to placing the air
handler (See Page 18, Section 9 for proper leg
mounting). Place the filter section so that the outward
flange is on the top side. Set the filter section into the
leg assembly. Place ½" foam tape (supplied by
others) along the perimeter of the top of the flange.
Place the air handler on the leg assembly per the
mounting instructions.
10.3.2 Filter Installation
Install the proper filters as required for the air
handler’s configuration. See Page 23, Table 7.
Table 7: Filter Quantities
Permanent Aluminum Mesh Pleated / Polyester*
Model Filter Size Total Quantity Poly P/N Alum P/N Pleated P/N
2005 25x25 1 P-000750 66509 21534
2010 20x20 6 P-000707 20596 35367
2010B
24x20 5 02243 P-000863 36370
20x20 5 P-000707 20596 35367
2020 25x25 12 P-000750 66509 21534
2030 24x20 24 02243 P-000933 36370
To Next Page
Loading...