Rapid Engineering 2000 Series - SECTION 11: Inlet Hood

To Next Page

To Previous Page

SERIES 2000 INSTALLATION, OPERATION AND SERVICE MANUAL

SECTION 11: INLET HOOD

Inlet hoods are shipped unassembled and must be assembled prior to installation. The inlet hood may be

installed either onto the inlet of the air handler or to an outside wall. After installing an inlet hood, all hardware

must be torqued according to recommended specifications on Page 6, Table 1. In addition, all seams must

be caulked (provided by others).

NOTE: Check to be sure that all required components are present. If any are missing, contact your RAPID

independent distributor.

Crush Hazard

Use proper lifting

equipment and

practices.

Falling Hazard

Use proper safety

equipment and prac-

tices to avoid falling.

Severe Injury Hazard

Use proper lifting

practices and equip-

ment.

Equipment and

accessories are

heavy.

Cut/Pinch Hazard

Wear protective gear

during installation,

operation and

service.

Edges are sharp.

WARNING

Failure to follow these instructions can result in death, injury or property damage.