Raritan PMC-1000 Quick Setup Guide

Power Meter Quick Setup Guid
e
14
QSG
-PMM-1A-v3.3.10-E  255-64-0004-00
Login and Configuration
Connect your PC directly to the PMM to complete the initial configuration.
 To access the web interface at the rack:
1. Disable the wireless interface of the PC.
2. Connect a cat 5 cable between the PC and PMM network ports.
3. Open a browser. Enter the URL "https://pdu.local". The login page appears.
If the URL does not resolve, use the IP address of the PMC. Retrieve the direct IP address using the LCD display: Menu > Device
Information, scroll to the IPV4 settings. Enter the IP address in the web browser:"https://IP address/"
4. Login with the default username and password. Allow 30 seconds for first connection.
 Username: admin
 Password: raritan
Configuring Power Meters and Branch Circuit Monitors
You can configure your product with a spreadsheet, or in the product's web interface.
 To configure with a spreadsheet:
Go to Raritan.com and download the configuration spreadsheet from the BCM2 Support page. Follow the instructions in the
spreadsheet.
 To configure with the product web interface:
Make a network connection to the product. See Login and Configuration (on page 13). Follow the instructions in this guide, starting
with: Scan Power Meters.
Configure Using the Web Interface
Scan Power Meters
1
Click Power
Meters.
2
If nothing is
configured, scan
begins
immediately in
the
Unconfigured
Meters section.
Click Rescan to
refresh the list.
3
Click the power
meter or panel
in the
discovered list
to configure it.
Types:
PM: 3-phase
Panel: BCM

Raritan PMC-1000 Specifications

General

Brand	Raritan
Model	PMC-1000
Category	Measuring Instruments
Language	English