8
Safety hints
Unloading
• Open the door slowly.
• Caution! Steam!
• Caution! Containers will be hot.
• When opening the door, the unit switches off
automatically.
• The fan continues to rotate until it becomes statio-
nary.
• Do not spray water into the hot cooking area.
• GN container catch for safe loading
Using the core temperature (option)
• The core probe can be very hot.
• Place the core probe in the holder provided when
not in use.
• Do not let the core probe hang freely outside the
cooking area.
• Make sure the core probe is not inserted into the
food when removing from the oven.
Working with mobile oven racks and
transport trolleys for table models
(option)
• The transport trolley must be fixed to the unit
properly.
• When transfering from the mobile oven rack to the
transport trolley beware of the safety catch.
• Use the wheel brakes provided on both rack and
trolley.
Additional function “Cool down”
• Caution! While the door is open during the cool
down phase the fan continuous to rotate.
• Only use the cool down function in accordance to
regulations when the air baffle system is closed.
General hints
• The temperature of the door glass can be higher
than 60 Kelvin as the temperature of the room.
• During long periods of non usage the main stopcock
should be turned off.
• Fasten the GN standard catering container catches
on floor models – for safe loading and unloading.
• Make sure, that the mobile oven rack is inserted
fully and the locking device is snapped into it’s
locked
position.
• Lack of water display flashes – check the water
supply.
Cleaning
• Spray the cleaning detergent using the original
RATIONAL hand pressure spray gun.
• Do not use a high pressure cleaner.
• Do not use acids or let acidic fumes come into
contact with the protective layer of the units
nickel chromium steel otherwise it will be dama-
ged and could become discoloured.
• Observe the handling instructions on the cleaning
detergent container (only spray into the cabinet
when the temperature is below 60 °C).
Descaling
• The SC-Automatic (self-clean) makes regular de-
scaling of the steam generator superfluous.
• In areas where water hardness is normal the
steam generator must be cleaned thoroughly every
1 2 months. This operation should be carried out by
our service department.
Maintenance
• Inspection and repair work should be carried out
by qualified electricians. Caution! The unit must be
disconnected from the power supply before ope-
ning the service door and working on live parts.
To Next Page
Loading...
Need help?
General
