APPENDIX
A
Manual No. 016-0130-076 Rev. C 41
A ppendi x A
PowerGlide Plus Mode
Overview
The AutoBoom UltraGlide and UltraGlide XT systems may be converted to operate in PowerGlide Plus mode if
desired. PowerGlide Plus mode may provide preferred operation characteristics for pre-emergence and burn-
down applications.
Requirements
In the PowerGlide Plus mode, gauge wheels must be installed to “feel” for the ground. The ultrasonic sensors
may still be used to monitor the boom height, however, the system will not use the measured sensor heights to
control boom height while the system is engaged in this mode. Contact a local Raven dealer for available kits
and purchasing.
To Next Page
Loading...
