Chapter 4
28 AutoBoom® Calibration & Operation Manual
AutoBoom
®
In-Job Prompt
In addition to the AutoBoom system power, the AutoBoom in-job prompt provides the following displays and
operator controls:
Section Status. The status indicators display the same status information and provide the same functionality
as the AutoBoom on-screen widget. Touch each section to enable or disable AutoBoom height control
features for the section.
Boom Pressures. Displays the current hydraulic pressure in the left and right boom cylinders.
Current Height. The monitored sensor heights for each implement section are displayed at the top of the
Diagnostics tab display. These values are the adjusted heights based upon the values set on the Sensor
Offsets tab.
Target Height. The target height sets the distance in inches [centimeters] above ground or the crop canopy to
which AutoBoom should control boom heights while the system is engaged.
Tuning Tab. (UltraGlide Systems Only) Provides the operator with access to the speed, sensitivity, stability
factor, and XT Gain values (if available) during an active job. Refer to the Tuning Tab section on page 16 for
information on adjusting the AutoBoom tune settings available in the in-job prompt.
Joystick Control Interface
The AutoBoom system power must be turned on or off via the AutoBoom widget before the system may be
enabled using the following joystick function controls. Review the AutoBoom® System Power section on
page 27 for details. With the AutoBoom system power on, the implement operator may use the implement
joystick functions in the following sections to quickly enable or disable automated boom height control for
individual sections:
Note: Holding the down function for longer than 1/2 of a second will disable AutoBoom height control and
allow the operator to lower the boom manually. To enable AutoBoom height control, tap and
immediately release the down function.
Consecutive up-taps or down-taps must be performed within 1.5 seconds to engage the double tap
joystick control functions.
To Next Page
Loading...
