CHAPTER 7
44 Raven RS1™ and RS Lite™ Calibration and Operation Manual
EXTERNAL GPS FOR RS LITE™
RS Lite will automatically configure the following Raven receivers to output the correct messages and message
rates:
• Raven 600S™
•Raven 700S™
•Viper 4/4+
• Viper 4/4+ Twin
If a different receiver is being used, configure the receiver output to the settings below before performing
calibration.
TABLE 1. GPS Receiver Message Settings
CONFIGURE GPS
FIGURE 3. GPS Setup Page
GPS SHUTDOWN TIMER
The GPS Shutdown Timer value determines the length of time the RS1 unit remains powered after the machine
switched power is turned off. The GPS remains converged for the length of time selected.
NOTE: The default value for the shutdown timer is 1 hour. This option requires that RS1 is installed properly
with both switched and constant power.
Baud Rate Message Type Frequency
115200
GGA 10 Hz
VTG 0.1 Hz
GSV 0.1 Hz
ZDA 0.1 Hz
GSA 0.1 Hz
GST 1 Hz
GRS 0.1 Hz
To Next Page
Loading...
Need help?
General
