Raven SCS 700 - Initial Console Programming

14
INITIAL CONSOLE PROGRAMMING
STANDARD DATA ENTRY PROCEDURE:
When entering data into any of the keys on the Console, the data entry sequence is always the same.
Depress the keys corresponding
to the number you wish to enter
(i.e., "1", "0", "2", "4",).
The numbers will be displayed in
the DATA display as they are
entered.
Depress the key in which
you wish to enter data.
Depress the "ENTER" key.
An "E" will illuminate in
the DATA display.
Complete the entry by again
depressing the "ENTER" key.