CHAPTER 1
2 Raven Switch Pro™ Installation & Reference Manual
MOUNTING TIPS
Use the supplied mounting hardware and bracket to mount the Switch Pro inside the vehicle cab.
NOTE: Refer to the Switch Pro Kit Contents section on page 6 for optional mounting bracket and hardware
components. Optional hardware components must be ordered separately.
Refer to the following tips when selecting a mounting location for the Switch Pro switch box:
• The switch box is not weatherproof. Mount Switch Pro inside of the machine’s cab or driver’s
compartment within easy reach of the driver or operator.
• Switch Pro should be mounted in a location where it will not be jarred during normal equipment
operation. Keep the console clear of moving elements within the machine’s cab.
• All cables connected to the Switch Pro switch box should be routed to avoid kinks in the cables and
tripping hazards.
If the Switch Pro will be mounted together with an Envizio Pro or Viper Pro field computer:
• Securely fasten the RAM mounting arm (Envizio Pro) to a suitable, flat surface. Once mounted, the
RAM mounting arm must provide a stable base for the console and should not move due to normal
machine operation.
• The Envizio Pro or Viper Pro field computer should be mounted in a location where it will not be
jarred during normal equipment operation. Keep the field computer clear of moving elements
within the machine cab.
• All cables connected to the Switch Pro system should be routed to avoid kinks in the cables and
tripping hazards.
SWITCH PRO/ENVIZIO PRO MOUNTING BRACKET
The Switch Pro/Envizio Pro mounting bracket (P/N 107-0171-841) mounts the Switch Pro switch box below the
Envizio Pro field computer.
1. Match up mounting posts on the Envizio Pro with the pre-drilled holes in the mounting bracket and the square
flange on the RAM socket arm.
a. The mounting bracket should not interfere with any cable connections or ports on the Envizio Pro field
computer.
To Next Page
Loading...
