Raven viper 4+ - Chapter 10 Serial Device Set Up; Serial Device Information and Detection

CHAPTER
10
Serial Device Set Up: 105
CHAPTER 10 SERIAL DEVICE SET UP
The following sections are intended to provide information on connecting external devices such as a differential
GPS, or DGPS receiver, light bar, or another serial device to the ROS device. For additional assistance or
information on available components, contact a local Raven dealer.
SERIAL DEVICE INFORMATION
The ROS device provides a list of detected serial devices connected to the system. To review the serial devices
currently detected by the ROS device:
1. Touch the Edit icon in the Machine Panel to view the machine devices.
2. Locate and select the serial devices module. The serial devices tab will display the following information for
each detected device:
• serial device name
• automatic or user configured communication settings
• current active communication (COM) port
• the input baud rate at which the ROS device is attempting to
communicate with the device
NOTE: The COM port displayed on the Serial Devices tab does not reflect the cable connector label to which
the device may be connected.
Redetect the serial devices if new devices are connected, or if an existing device connection is changed for any
reason.
SERIAL DEVICE DETECTION
To redetect serial devices connected to the system:
1. Touch the Edit icon in the Machine Panel to view the machine devices.
2. Locate and select the serial devices module. The Serial Devices tab will display.
Edit
Serial Devices
Serial
Devices
Auto Detected
Devices
User Setup
Devices
Edit Serial Devices
Serial
Devices
Redetect
Serial
Devices