CHAPTER 7
58 Viper/Viper 4+ Installation & Operation Manual
9. With at least one file selected, select one of the following import actions:
•Copy - create a duplicate of the selected information on the ROS device.
•Move - import the selected information to the ROS device and remove the information from the USB
flash drive.
The Import Files prompt will display.
10. Verify the list of files to be imported is correct. If the list requires further configuration, touch the Cancel button
to return to the USB Manager tab.
11. Touch the Import button to begin the file transfer process.
IMPORT ISO TASKDATA
The import ISO TASKDATA section provides options to import data from Slingshot or a USB stick. This information
can be GFF data or field boundaries.
12. Refer to the ROS Slingshot Field Calibration and Operation Manual for additional information on using a
Slingshot Field Hub with the ROS device.
FILE TRANSFER HISTORY
If a Slingshot Field Hub is connected with the ROS device for wireless communication, the File Transfer History tab
may be used to track and review transfer history via the Field Hub.
Refer to the ROS Slingshot Field Calibration and Operation Manual for additional information on using a Slingshot
Field Hub with the ROS device.
FILE MANAGEMENT OPTIONS
The File Management Options tab is currently only used if a Slingshot Field Hub is connected to the ROS device. If
a Field Hub is not installed, it is not recommended to leave the “Send Jobs to Slingshot” option enabled.
Refer to the ROS Slingshot Field Calibration and Operation Manual for additional information on using a Slingshot
Field Hub with the ROS device.
To Next Page
Loading...
