CHAPTER 11
118 Viper/Viper 4+ Installation & Operation Manual
6. Review all implement sections currently assigned to the on-screen switch function.
7. To change switch assignments, touch the Change Assignment button. Only unassigned sections will be
displayed on the section assignment screen for the selected switch. To reassign a section to a different switch
function, the section must first be unassigned from the current switch.
CANBUS TROUBLESHOOTING
Although the control algorithm is located within the CAN node, all of the same troubleshooting techniques that
are used in a traditional hard-wired or serial control systems still apply to a CAN system and the behavior of the
system remains the same. Flow and speed sensors, as well as the control valve and boom valves, are used in the
same fashion.
Refer to the Raven CAN Network Installation Manual for additional troubleshooting and CAN system information.
To Next Page
Loading...
