CHAPTER
9
Differential GPS (DGPS) Set Up: 87
CHAPTER 9
DIFFERENTIAL GPS (DGPS) SET
UP
GENERAL GPS INFORMATION AND SETTINGS
GPS solution information may be displayed by ROS to allow the operator to verify message and correction
information received by the ROS device during operation.
REDETECTING DGPS DEVICES
If a GPS device is connected after the ROS device is powered on, or if the device is not available, it may be
necessary to redetect serial devices. Check all cabling connections and refer to the Serial Device Detection section
on page 105 for assistance with redetecting and reinitializing serial communications.
GPS SOLUTION INFORMATION
1. Touch the Edit icon in the Machine Panel to view the machine devices.
2. Locate and select the GPS module. The GPS Global Settings prompt will display.
3. Press the GPS Configuration icon to the right of the desired GPS receiver. The Differential Settings tab will open.
4. Navigate through the tab while referring to the information below.
SOLUTION INFORMATION
Latitude/Longitude. The current geographic coordinates of the ROS device.
To Next Page
Loading...
