EasyManua.ls Logo

Raven viper 4+ - Page 94

Raven viper 4+
182 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CHAPTER 8
86 Viper/Viper 4+ Installation & Operation Manual
Wired As. Use the “wired as” field to set the physical “boom” sense or valve connection used for each configured
section and to reorder sections in the group for accurate display during a field operation.
NOTE: Raven boom sense cables are color coded as follows:
The above section numbers assume that section 1 is located at the far left of the implement and
section 16 is at the far right. Some OEM installations may connect these leads differently than
indicated above. For additional assistance with switch lead or valve connections, refer to the Raven
CANbus Installation Manual or contact a local equipment dealer.
Fence Row. Select the fence row option to designate the configured section as a fence row. The ROS device will
not include sections assigned as fence rows in overall guidance width calculation. Guidance width and offset
may still be overridden on the Machine Configuration tab. Refer to the Machine Configuration Tab section on
page 76 for additional assistance.
SECTION OFFSETS
Left/Right Offset Direction. Touch the left/right offset direction drop down and select the direction from
the center of the boom or implement to the center of the section.
Left/Right Offset Distance. Select the offset distance field and enter the distance from the center of the
boom or implement to the center of the section in inches [centimeters]. The left/right offset distance must be
measured perpendicular to the direction of travel.
Fore/Aft Offset Direction. Touch the fore/aft offset direction drop down and select the direction from
the center of the boom or implement to the center of the section.
Fore/Aft Offset Distance. Select the offset distance field and enter the distance from the center of the
boom or implement to the center of the section in inches [centimeters]. The fore/aft offset distance must be
measured parallel with the direction of travel.
Section
Number
Lead Wire Color
Section
Number
Lead Wire Color
1. Black 9. White/Blue
2. Brown 10. Pink
3. Blue 11. Yellow/White
4. Black/White 12. Green/White
5. Brown/White 13. Red/White
6. Blue/White 14. White/Yellow
7. White/Black 15. White/Green
8. White/Brown 16. White/Red

Table of Contents

Other manuals for Raven viper 4+

Related product manuals