CHAPTER 3
12 Viper/Viper 4+ Installation & Operation Manual
3. Touch the Tractor Name field and use the on-screen keyboard to enter the name or designation for the vehicle
or tractor used with the profile.
FOR EXAMPLE:
When setting up a configuration for a pull-type sprayer, the operator might enter the configuration name as
“Liquid Applicator” and the tractor nickname as “Front Wheel Assist.”
4. Select done on the machine configuration tab to return to the machine panel.
5. Locate and select the CAN system icon in the machine panel editor to view CAN system information.
6. Verify that all CANbus nodes are detected and displayed by the ROS device.
7. Readdress any product control nodes connected to the CANbus at this time.
8. Verify any multi-channel nodes are configured correctly for the control channels necessary for the equipment
during field operations. Refer to Chapter 11, CANbus Device Set Up, for details on readdressing product control
nodes and configuring multi-channel control nodes.
9. Finish the machine configuration setup. Refer to Chapter 8, Machine Panel and Configurations, for details on
setting up and completing machine configurations.
10. If desired, enter product information to set up a product configuration during the initial set up. Refer to the
ROS Product Control Calibration and Operation manual for additional assistance with configuring product
profiles.
11. If desired, set up Job Profiles for various field operations during the initial set up process if desired. Refer to
Chapter 13, Job Profile Panel and Configurations.
Done
CAN
System
Readdress
CANbus
To Next Page
Loading...
