Chapter 4: Using the Chartplotter 73
• You can include a waypoint more than once in a route but the same waypoint
cannot be placed consecutively.
• You can create a new route when the route list is full but on saving this, you
are prompted to choose an existing route to overwrite.
Building Routes using Waypoints on Screen
You can build a route on screen that consists of either new or existing waypoints.
... using new waypoints
You can build routes using a series of new waypoints.
1. Press ROUTES and then NEW ROUTE.
2. Press PLACE WAYPOINT.
A new waypoint is placed at the cursor’s position.
• If you make an error when you are building your route and wish to remove
the last waypoint, press UNDO WAYPOINT. The waypoint and its dotted
line are removed from the screen and the cursor moves back to the previ-
ous waypoint. If you repeatedly press these keys, successive waypoints
are removed.
• If you wish to abandon the route that you are building, press
CANCEL.
You are asked to confirm your request to delete the route.
3. Move the cursor to the next position.
The cursor is joined to the waypoint with a dashed line. As subsequent way-
points are added, the dashed line becomes a solid line.
ROUTES
D8097-2
PLACE
WAYPOINT
NEW ROUTE
To Next Page
Loading...
