Chapter 5: Installing the ST4000+ 57
5 Installing the ST4000+
Compass - recommended location for steel-hulls
Mounting
Fluxgate compass - orientation
CAUTION:
You must mount the fluxgate compass on a vertical bulkhead,
with the cable exiting at the base.
1. Hold the compass against the mounting location.
2. Mark the four mounting holes, then remove the compass.
3. Drill four pilot holes using a 3 mm (
1
/
8
in) drill bit.
6 ft (1.8 m)
D5383-1
4 ft (1.2 m)
4 ft (1.2 m)
D
5384-1
Vertical
To Next Page
Loading...
