Chapter 7: Adjusting Autopilot Settings 87
7 Adjusting Autopilot Settings
7.4 Seatrial Calibration
The Seatrial Calibration group has been designed specifically for use
during the initial seatrial when commissioning your autopilot. Refer
to Chapter 6: Commissioning the Autopilot for full details.
CAUTION:
You should not need to access Seatrial Calibration to adjust
settings during normal autopilot operation.
Note: If you are connecting the ST6001+ to a non-150/400 autopilot
system, the Seatrial Calibration group is not available. You will need
to use the Compass Calibration group instead. Refer to the Appendix
for full details.
To Next Page
Loading...
