Raymarine E120W - Chapter 4: Managing Display Data; CompactFlash Card Usage and Data Transfer

Chapter 3: Installation 35
... to replace a Raymarine Pathfinder Display
The array and the display should be connected using the pedestal adaptor cable as
shown:
Connecting to a radome
If you are using a radome this can be powered through the display, run your cable and
connect it to the radome and the display.
Part No Description
E55069 2.5m Pedestal adaptor cable
Part No. Cable length Weight Radome power output
E55065 15m Heavy 2Kw or 4 Kw
E55066 25m Heavy 2Kw or 4 Kw
E55067 10m Light 2kw
E55068 15m Light 2kw
Pedestal adaptor cable
D7327-1
To display
To open array
connector
To power
Pedestal adaptor cable
(2.5 metres)
PAGE
ACTIVE
WPTS
MOB
MENU
DATA
CANCELOK
RANGE
IN
OUT
D7328-1
Open Array
Boats DC
Power Supply
E-Series Display
Power to display
Power to open array
Note: The power supply for both the display
and the open array must be of the same
voltage (using a convertor if necessary) and
from a common supply source e.g. the same
battery or power breaker.