Raymarine EV-100 - Route the cable through the pedestal (or guard rail) and back to the control unit; Run the drive cable back to the control unit and connect the two cores to the Drive terminals as shown.

17
2. Route the cable through the pedestal (or guard rail) and back to the
control unit:
• if the pedestal has a cable duct, use this for the drive cable to
make sure that it cannot foul the steering mechanism
3. Run the drive cable back to the control unit and connect the two
cores to the Drive terminals as shown.
D5338-1
81131_8.book Page 71 Thursday, October 7, 2004 11:03 AM