5.2 Mounting
Pre-mounting check
The product is designed to be surface mounted. Before mounting
the unit, ensure you have:
• Selected a suitable location.
• Identied the cable connections and route that the cables will take.
Mounting diagram
Mounting instructions
1. Check the selected location for the unit. A clear, at area with
suitable clearance behind the panel is required.
2. Fix the supplied mounting template to the selected location,
using masking or self adhesive tape.
3. If possible use an appropriate size hole cutting saw to cut-out the
center hole area as indicated on the mounting template; or
4. Using a suitable hole cutting saw, make pilot holes in each
corner of the cut-out area, and using a jigsaw cut along the
inside edge of the cut-out line.
5. Ensure that the unit ts into the removed area and then le
around the cut edge until smooth.
6. Peel the backing off the supplied gasket and place the adhesive
side of the gasket onto the display unit and press rmly onto
the ange.
7. Screw the supplied mounting stud into the back of the unit.
8. Feed cables through the supplied clamping bracket and connect
to the unit.
9. Secure the instrument and bracket using the thumb nut and stud.
5.3 Bracket mounting
To bracket mount the unit, follow the instructions supplied with the
mounting bracket (Part number E25024).
Location and mounting
25
To Next Page
Loading...
