Using the wind pages
To cycle through the wind pages follow the steps below:
Note: The High wind speed alarm page is only available on
master units (See the Data master section for details), it is a
temporary page which will time out after 5 seconds to the previous
permanent page.
1. With the Apparent wind page displayed:
i. Press the Up button to display the High wind speed alarm
page, or
ii. Press the Down button to display the True wind page, or
iii. Press the Action button to apply the current wind bearing as
the locked heading and display the Locked apparent wind
angle page.
2. With the True wind page displayed:
i. Press the Up button to display the Apparent wind page, or
ii. Press the Down button to display the High wind speed
alarm page.
3. With the High wind speed alarm page displayed:
i. Press the Up button to display the True wind page, or
ii. Press the Down button to display the Apparent wind page.
4. With the Locked apparent wind angle page displayed:
i. Use the Up and Down buttons to adjust the locked wind
angle, or
ii. Press the Action button to return to the Apparent wind page
Using your display
43
To Next Page
Loading...
