3 Setup and Calibration
3.1 Entering Setup and Calibration Mode
To enter the Setup and Calibration menu press and hold for 2 seconds
the button.
This will not work when in the Race Timer page.
3.2 Chapter and Page Setup and Calibration
Setup and Calibration is displayed in a "Chapter and Page" format using
the button to scroll through the chapters and the and
buttons to move between pages. The diagram shows the information
format.
Unlike normal operation you must scroll to the chapter heading
page before moving to another chapter.
For a full description of each page refer to items s1 to s45 on the
following pages
3.3 Editing Values
To adjust any settings press the button. The setting will start to flash
and the and buttons will change the value. Then press the
button again to save the new setting.
mn100 Digital Display
18
www.raymarine.com
To Next Page
Loading...
