Raymarine P70 - Before Using Your Product; Powering the Pilot Controller On

p70rMounting
D12 1 05-1
1.Checktheselectedlocationfortheunit.Aclear,atareawith
suitableclearancebehindthepanel,isrequired.
2.Fixtheappropriatecuttingtemplatesuppliedwiththeproduct,to
theselectedlocation,usingmaskingorself-adhesivetape.
3.Usingasuitableholesaw,makeapilotholesineachcornerof
thecut-outarea.
4.Usingasuitablesaw,cutalongtheinsideedgeofthecut-outline.
5.Ensurethattheunittsintotheremovedareaandthenle
aroundthecutedgeuntilsmooth.
6.Drillfourholesasindicatedonthetemplatetoacceptthe
securingscrews.
7.Peelthebackingoffofthegasket,andplacetheadhesivesideof
thegasketontothedisplayunitandpressrmlyontotheange.
8.Connectcablestotheunit.
9.Slidetheunitintoplaceandsecureusingscrewsprovided.
Note:Drill,tapsize,andtighteningtorqueisdependentonthe
thicknessandtypeofmaterialtheunitistobemountedon.
Locationandmounting
33