14 RayPilot 650 Control Unit - Owner’s Handbook
2 Using the RayPilot 650
RESP
• Momentary press to display current rudder gain level.
• Press and hold for 2 seconds to display current response level.
• You can then make temporary adjustments to the displayed
values using either:
•
LIGHTS ▼ to decrease the level
•
NAV ▲ to increase the level
• or the course change knob
Note: You can make permanent adjustments to response and rudder
gain in Calibration mode.
LIGHTS and RESP
• Momentary press of LIGHTS and RESP together will switch on
the Watch Alarm timer (not available from Standby or Power
Steer modes).
D860-1
D1007-1
81013_4.book Page 14 Wednesday, July 25, 2001 11:04 AM
To Next Page
Loading...
