26
Clutch
Raymarine drives
Raymarine drives have a 12 V clutch. The clutch switch default setting on the SPX
SmartPilot is 12 V.
Non-Raymarine drives
• SPX SmartPilots are compatible with other manufacturers’ drives, which have
either 12 V or 24 V clutches.
CAUTION: If the drive unit has a 24 V clutch, move the clutch fuse switch
on the SPX SmartPilot to the right. Do not confuse the operating voltage
of the clutch with the voltage used on the boat.
To mount the drive unit
• Fit the drive unit (hydraulic, mechanical or solenoid) to the steering system,
following the installation instructions supplied with the drive.
Note:
You will need to power the drive unit with a cable routed from the SPX SmartPilot (see
Power and drive cables
on
page 27
).
12V Clutch
D10452-1
24V Clutch
D10453-1
87072-2.book Page 26 Thursday, November 22, 2007 8:43 AM
To Next Page
Loading...
