40
3.13 Test the system
Switch on
• Switch on the main power breaker.
SeaTalk
ng
• If you are using an ST70 autopilot controller and it does not power up:
• Switch it on by holding down the Power button for 1 second.
• If the SPX SmartPilot and autopilot controller are active, the autopilot control-
ler should display a select LANGUAGE menu.
Troubleshooting
• If the display is blank, check the fuse/circuit breaker, the SeaTalk
ng
fuse in the SPX
SmartPilot computer and that the SeaTalk
ng
power switch is set to ON.
• If the display shows the SEATALK
ng
FAIL or NO DATA alarm message, check the
SeaTalk
ng
connections and terminators.
SeaTalk
• If you are using a SmartPilot controller (ST6002, ST7002 or ST8002) and it
does not power up:
• Hold down the Display button for 1 second.
• If the SPX SmartPilot and autopilot controller are active, the autopilot control-
ler should display a STANDBY screen.
Troubleshooting
• If the display is blank, check the fuse/circuit breaker, the SeaTalk fuse in the SPX
SmartPilot computer.
• If the display shows the SEATALK
ng
FAIL or NO DATA alarm message, check the
SeaTalk
connections and terminators.
• If the STANDBY screen does not display a live compass heading or a rudder
angle, check the sensor connections.
3.14Final fix
After connecting any additional components, make sure the system is powered down
before finally securing all equipment properly in place.
87072-2.book Page 40 Thursday, November 22, 2007 8:43 AM
To Next Page
Loading...
