Raymarine ST70 - Page 19

Chapter 2: Commissioning Procedures 13
4. Press ENTER to display the Transducer Setup
start search page.
5. Press ENTER again, to initiate a system search
for transducers.
At the end of the search a Search Results page
is displayed.
6. With the search results page displayed, press
ENTER to display the Transducers found menu.
7. Use
< or > to scroll to Depth.
8. Press ENTER to display the Depth transducer
menu.
9. With the Depth transducer menu displayed, use
< or > to scroll to the Depth Offset option.
10. Press ENTER , to display the Depth Offset setup
page.
11. Check the type and value of the offset currently
applied:
• If the offset type is what you require and the
value is correct for your boat, press
CANCEL to return to the Depth transducer
menu, then proceed from step 16.
• Otherwise proceed from step 12.
Press ENTER to continue
Transducer Setup
ST70 will now search
the network for
transducers. Press
CANCEL to stop.
D10359-1
Press ENTER to continue
Search Results
Found:
D10064-1
1 Depth
1 Speed
1 Wind
i
If not correct, press CANCEL and
check connections.
D9781-1
Press ENTER to select.
Transducers found
Depth
i
Raymarine
Serial no. 100020
Press ENTER to select
Depth
Verdana 6.5 pt
Depth Offset
i
D10056-1
Raymarine
Serial no. 100020
D9782-1
2.5
Keel
ft
Depth Offset
i
Warning! Incorrect offset may
lead to vessel running aground.
Press ENTER to accept
81284_1.book Page 13 Friday, May 4, 2007 7:29 AM