Raymarine ST70 - Return to Normal Operation; After Commissioning; EMC Conformance

Chapter 2: Commissioning Procedures 23
2.3 Return to normal operation
When you have completed all the appropriate dockside setup and seatrial calibration
procedures, return to normal operation as follows:
1. With the Transducers found menu displayed, press
CANCEL to select the Search
Results
screen.
2. Press
CANCEL to select the Transducer Setup screen showing the search
initiation message.
3. Press CANCEL to select the Advanced options menu.
4. Press
CANCEL to select the Main Menu .
5. Press
CANCEL to return to normal operation.
2.4 After commissioning
When the dockside setup and seatrial calibration have been completed, and you have
returned to normal operation, your ST70 instrument is ready for use. Refer to the
ST70 Operating Guide for instructions on how to use it on a day-to-day basis.
EMC Conformance
Always check the installation before going to sea to make sure that it is not affected by
radio transmissions, engine starting etc.
81284_1.book Page 23 Friday, May 4, 2007 7:29 AM