Raymarine ST70 - Following a Route (Track Mode)

Chapter 3: Setup Procedures 27
Setting time format
1. At the Time & Date menu, use < or > to scroll to the Set time format option.
2. Press
ENTER to display the Set time format box,
then use
< or > to select either 12 hour or 24
hour format, as required.
3. Press
ENTER to save the setting and return to
the
Time & Date summary page.
4. Use the Leaving time/date setup procedure
below, to return to your operational page.
Note: If you want to set the correct local time, refer to the
ST70 Instrument Operation Guide.
Setting date format
1. At the Time & Date menu, use < or > to scroll to
the
Set date format option.
2. Press
ENTER to display the Set date format box,
then use
< or > to select either dd/mm/yy or mm/
dd/yy format, as required.
3. Press
ENTER to save the setting and display
the
Time & Date summary page.
4. Use the Leaving time/date setup procedure
below, to return to your operational page.
Leaving time/date setup
With the Time & Date summary page displayed:
1. Press
CANCEL to return to the Display Settings
menu.
2. Press CANCEL to return to the Main Menu .
3. Press
CANCEL to return to your operational
page.
D9779-1
12-hour
Press ENTER to accept
Set time format
i
Use < & >to adjust.
CANCEL exits without saving.
D9542-1
i
i
Press ENTER to accept
Set date format
dd/mm/yy
< & > to adjust.
CANCEL exits without saving.
D9424-1
i
Time 11:01:03
Date
14/06/07
Time Offset -1 Hrs
Time Format 24-hour
Date Format
dd/mm/yy
These are your current settings.
Time & Date
Press ENTER to continue
81284_1.book Page 27 Friday, May 4, 2007 7:29 AM