8 Transducers for Fishfinders
• Ifthepropeller can be turned tosteer the boat,allow atleast2" (50
mm) beyond the swing radius of the propeller. This will prevent
the propeller from damaging the transducer when it is turned.
Figure 1-1: Transom Mount Transducer Location
• Do Not mount the transducer behindany hullfittings, intakes or
other parts extending from thehull that may cause turbulence or
air bubbles.
• The bracket has a quick-release mechanism, shown Figure 1-2 .
This allows the transducer to flip up if it hits any debris or the bot-
tom.Allow enoughclearance abovethe transducer for ittoswing
upwardscompletely– thisisabout10"(254mm), measuredfrom
the bottom of the transom.
Be sure to allow at
least 2 in (50 mm)
beyond the swing radius
of the propeller
Approximately 18 in (457 mm) clearance
D4871-2
To Next Page
Loading...
