EN
13
Note:Note:
Note:Note:
Note:
You cannot adjust the dimmer
in CD and radio mode.
Tip:Tip:
Tip:Tip:
Tip:
Only alarm tone can be se-
lected in NAP mode.
Alarm Settings
Nap Mode
For catnaps up to 2 hours without disturb-
ing the regular alarm settings, the NAP
function wakes you up after a short pe-
riod of time. Simply:
1. Press NAP, the NAP indicator will flash.
While the NAP indicator is flashing,
press << or >> to adjust nap time. The
time range is from 10 minutes to 2 hours
at 10 minutes interval.
2. Press NAP again to confirm, the NAP
indicator will show on the display.
3. Press NAP once to show time left.
Stopping the Nap Alarm
When the NAP alarm sounds, you can
press OFF to stop it.
Cancelling the Nap Alarm
Press and hold NAP for 5 seconds to
cancel the nap setting.
Snooze
This operation allows extra sleep time after
the alarm is on. The alarm will be off by
pressing SNOOZE until the snooze period
is over. Snooze function can be used
repeatedly up to 2 hours. After this, the
alarm will turn off until the next alarm
conditions are met. Set the “quiet” period
as follows:
1. While pressing SNOOZE, press << or >>
to set the “quiet” period (the default
time is 9 minutes) from 1 minute to 30
minutes. Release button, then the
“quiet” period is set.
Weekend Cancel
Wake settings are activated during Mon
to Fri, but are cancelled on Sat and Sun.
(Work only when wake setting is active)
1. Press and hold WEEKEND CANCEL for
5 seconds.
2. The WEEKEND CANCEL icon will ap-
pear on the display.
3. Press and hold WEEKEND CANCEL for
5 seconds to disable the Weekend Can-
cel function.
Adjusting the Dimmer
Press << or >> to adjust dimmer level.
Default is the brightest.
To Next Page
Loading...
