Your Remote Control
Pleasebe sure you have inserted the batteries into the remote control (see
relevant section on page 3.) You can test it by pressing any button, tf it
works, the red LEDwill light.
1. ON/OFF ber while the word issti flashing
Toturn on or off the receiver and and the frequency will be stored.
other auxiliary components (see (For details, refer to "Storing and
page 10 "Using the Remote to Recalling Stations in Memory" on
Control Additional Components"). page 10.)
2. Source Buttons 9. Operation Buttons
Toturn on and select various In TUNER mode, you can press
audio/video sources. You can also REVERSEand FORWARD keysto
enter the BChannels direct input tune down or up the radio fie-
mode by pressing DVD.GCH quency. PLAY, RECORD,STOP
and PAUSEkeys are for easycon-
3. CH+, CH- (Channel Buttons) trol of components (like CD,TV.
Toselect programmed stations (in DVD, TAPE,etc.) other than the
TUNER mode), receiver itself. What you need isto
4. VOL (Volume Buttons)
Toadjust the volume.
5. MUTE
To mute all audio outputs.
; 6. Adjustment Buttons
PressAUDIO button to activate
the control, then upon pressing
OK, the display wilt toggle among
Preset EQ(Stereo only), SLEEP
encode the components in
advance. (Fordetails, refer to
"Using the Remote to Control
AdditionalCcomponents" on page
10.]
CLEAR
,@2@3@
4@,@ 0@
,@ °@ 0@
EN_EE; @ A_MS
REVERSE PLAY FORWARD
RECORD STOP PAUS_
AUD 0 DIG TALLEVEL 5URR
lO. DIGITAL
Selectthe way your audio/video _ ,_,_
components are connected to the sound settings. The display witt
receiver - Analog, Optical. or
Coaxial. toggle among DOLBY DIGITAL.
DOLBY PRO LOGIC, DOLBY 3
STEREO,STEREOand DSP modes.
Mode & DIM Mode. When the 11. LEVEL
display shows the setup you want Pressto adjust the volume of indi- "
Pressre 't (For details, refer to section i
to change, pressthe left and right viduaI speaker, peatea y "Advanced Sound Control" on
arrow buttons beside OK button and the display will toggle among page 11.) '"
to make changes, then pressOK to different channels (Left main i':
finalize your choice, speaker, Right main speaker, i
Note: The remote buttons GO
Center speaker,Left surround BACK.DISK GUIDE.RDM,PTY,
i
7. Number Buttons speaker, Right surround speaker, INFOoRDS, CLEAR,INPUT.SEEK i
Toaccessdirectly a pre-set station and/or Subwoofer, if available), & ANT.FMS do not work with the i
(in TUNER mode), then pressthe left and right receiver, i
arrow buttons beside OK button i
! 8. MENU for adjustment.
Pressto store desired frequency in i
memory. The flashing word MEM- 12. SURR (Surround Sound ":
CRY in red will appear in display. Control) i
Input your desired channel num- Pressto change the surround :,
•-................................................................................................................................................................................ ...°"
9
To Next Page
Loading...
