Troubleshooting Tips
Receiver/TunerOperation
STEREO indicator is off.
• Adjustthe antenna.
The signal is Mono. Severe hum or noise.
• The signal istoo weak. Connect an external anten-
na.
Remote ControlOperation
Theremote controldoes not operatethe unit.
• Another function mode isselected on the remote.
Pressthe correct Source Button.
• No batteries installed. (included with your system)
Install the batteries before attempting to operate the
remote. Be sure to match the + and - ends of each
battery to the symbols shown in the remote battery
compartment.
• The batteries are weak. Replace all batteries.
• The remote isnot pointed atthe remote control
sensor on the main unit or there is an obstacle
between the remote and the main unit.
• The remote control istoo far from the main unit,
move closer.
General
No audio.
• Make sure the speakers are connected.
• Check the connections.
• Check the power cord connections.
• Make sure the MUTE indicator on the front panel
isoff.
• Make sure the digital setting (optical, coaxial or
analog) iscorrect.
• Check if connections isdifferent from recommen-
dation when SDETisON (see p.12 Smart Detect).
No audio from one channel.
• Check the speaker level setting.
• Check the speaker wire or cable connections.
Noise creates when the TV is turned on.
• TheTV istoo close to the audio system.
Specific instruments sound displaced.
• Check the connections between the receiver and
the speakers if the sound does not match the video.
• Pressthe Source Button for the video source.
CleaningtheExterior
• Disconnect the system from AC power before
cleaning the exterior of the system with a soft dust
cloth, or with a slightly humid chamois leather. Never
use strong solvents.
Equipment Specifications:
AMPLIFIER SECTION:
All 5 channels: each 100W at 6 ohm.
0.9% THD @1kHz
Subwoofer channel: 200w at 3 ohm (RT2500only)
Muting Attenuation: 65dB
Frequency Response:40Hz to 20kHz +/-3dB
Signal to Noise Ratio: 65dB (Bypassmode)
VIDEO SECTION:
Input (Sensitivity/Impedance ):lVp-p/75ohm
Output (Level/Impedance): lVp-p/75 ohm
Frequency Response:10Hz to 6MHz at +/- 3dB
Signal to noise ratio: 40dB
Crosstalk @3.58MHz: 40dB
AM TUNER SECTION:
Frequency Response:80Hz - 2kHz +/-6dB
Usable Sensitivity: 800uV/m @S/N 20dB
Signal to Noise: 38dB
Image Ratio: 27dB @1000kHz
IFReJection:35dB
FM TUNERSECTION:
Frequency Response:40Hz- 15kHz +/-3dB
Quieting: 24dBu
Signal to Noise: 60dB(stereo)/ 65dB(mono)
Image Ratio: 40dB
IFReJection:50dB
•,o................................................................................................................................................................................ °.o"
4
To Next Page
Loading...
Need help?
General
