iiiiiiiii
iiiiiiiii
iiiiiiiii
iiiiiiiii
iiiiiiiii
i
Red/Black(Main Speakers), Blue/Black (Center i
Ctia_onnec__no the Antennas Speaker) and Grey/Black (Rear Speakers).When con-
The AM and FM antennas connect to the AM and necting the speakers, make sure the colors of speak-
FMterminals on the system'sback panel. They must er wires and terminals are matched. If the cords are
be hooked up in order to receive clear reception, reversed, the sound will be distorted and will lack i
Uncoil the antenna wires and locate the bare ends. bass. ::
Pressdown on the tab to open the terminal and
insert the wire. Snap the tab closed. After connect-
CENTER
__ ;_j ing the antennas, extend SPEAKER MAINSPEAKERS
Antenna and Speaker them to their full length
Wire Connection and adjust their positioning
for better reception.
Connecting the
Push Speaker t ...... , tab Speakers
down to qser[ wire
At least two front speakers
(left and right) are required.
For better sound quality,
Center speaker,rear speak-
ers and Subwoofer are pre-
Release tab to lock wire in
theterminal ferred. Adding center and _ UsethBjackontheleftback
NOTE:Makesuretheinsulation rear speakers wiltenhance L_ j oaoe_fo,_n,,eot,nooowered
is comple[el_ removed trom the sub woofer
ends of the Antenna anc surround effects. Adding a SURROUND SOUND SPFAKERS
speaKer wires at alI connection
points Subwoofer will increase _ ,_
bassresponse, i
If you want to enjoy full range of sound effects, with
small speakers, it isa must to usethe subwoofer For RT2500.connect the subwoofer with the audio :
with the speakers to maintain adequate basssignal cord (brown/black) provided. For RT2500R,or if you :
for the surround sound effect, want to connect your own powered subwoofer, a
monoaural audio core (not supplied) is needed.
Speaker cords, 1for each speaker, are needed for i
connection. Twist the stripped ends of speaker cord This receiver offers a high flexibility for user to use a .
about 2/3 inch (15 mm). Pressdown on the tab to large variety of speakers and subwoofers. For more
open the terminal and insert the wire. Snap the tab nformation please refer to section "Fine Setting of
closed. To easespeaker connections, the speaker the Speakers" in "Advanced Sound Control" on
cordsand the terminals are color-coded into: page 12.
oo................................................................................................................................................................................ ,oO°
5
To Next Page
Loading...
Need help?
General
