The Built.in
Radio
The receiver has
built-in AM/FM
radio function.
You can simply
connect it to
power and speak-
m
receiver or remote
ers to listen to your favorite radio stations.
1.Select TUNER.
2.Tune to your favorite station.
3.AdJust volume.
4.Set preset EQif needed
5.Set surround mode if needed.
Seek Tuning
You can keep pressing one of the
TUNING buttons on the unit or REVERSE/
FORWARD buttons on the remote for a
second, and the receiver will search for
[he next available station for you.
0000_
control; then pressMENU on the "
remote control. The flashing word
MEMORy in ida Will appear in display.
While the word MEMORY s stil flash-
ing, input your des red channel number
and the frequency wil! be Stored,
E
After you have done so, YOUcan r°tate i
the MULTI JOG on receiver or pressCH+ [
or CH. buttons on remote to Selectthe i
preset Stations directly, i
Note: The CH+ and CH- buttons i
respond 0nly in TUNER mode in Case i
Using the Receiver to Play DVD or
CD or Video Cassette Player
After you have connected your DVD or CDor VCR
player with the receiver,you can partly control them
through your receiver:
1. Connect the DVD or CDor VCRplayer with the
receiver. (For details, refer to page 4.)
2. Select DVD or CD or VCR according to the source
connected.
3. Turn on the connected player and start playback.
4. Set PresetEQ if needed. (For details, refer to item
11 "Preset EQ" on page 8.)
5. Set Surround Mode if needed. (Fordetails, refer to
"Advanced Sound Control" on page 12)
6. Set Night Mode if needed. (Fordetails, refer to
"Night Mode" on page 12.)
7. AdJustVolume.
Using the Remote to Control
Additional Components
You can set your remote to control other components
(like CD,TV,DVD, TAPE,etc.). What you need isto
encode them in advance (not necessaryfor recent
RCA& Proscan models)
1.Turn on the component to be programmed.
2. Look up the brand and corresponding code num-
ber in the code list from page 15to17.
3.While keeping the corresponding Source Button
(like VCR1, VOR2, TV, DVD) on the remote pressed,
enter the code from the code list through the
Number Buttons.
4. Releasethe component button, then press
ON,OFF to seeif the component will be turned off.
5. If this does not work, repeat steps 3 and 4 bytrying
to use the next code (if available) listed for the brand
of your component until the component responds to
°%.. ................................................................................................................................................................................. ,°°"
lO
To Next Page
Loading...
Need help?
General
