RCm SLALOM - Troubleshooting Guide

45
TROUBLESHOOTING
PROBLEM CAUSE CORRECTIVE ACTION
THE WEEPER FAILS TO PICK UP LARGE PARTICLES OF DIRT
OR LEAVES TRACES OF DIRT BEHIND.
WORKING SPEED TOO FAST REDUCE WORKING SPEED
BRUSH PRESSURE TOO LIGHT ADJUST BRUSH PRESSURE
B
RUSHES WORN ADJUST BRUSH PRESSURE OR REPLACE BRUSHES
BRISTLES BENT, OR STRING OR WIRE, ETC., ENTAN-
GLED IN BRUSH
REMOVE STRING OR WIRE
SWEEPER LEAVES DUST ON FLOOR OR DUST COMES
OUT FROM SIDE FLAPS
DUST FILTER CLOGGED CLEAN FILTER
FLAPS BADLY ADJUSTED OR WEAR CHECK FLAPS AND REPLACE IF DAMAGED
SWEEPER FAILS TO PICK UP PAPER, LEAVES, ETC.FRONT FLAP LIFTING MECHANISM NOT WORKING CHECK OR REPAIR FLAP MECHANISM
SWEEPER THROWS DIRT FORWARDS FRONT FLAP DAMAGED REPLACE
THE MAIN BRUSH LIFTS THE FRONT FLAP FRONT FLAP TOO LONG REPLACE
RAPID BRUSH WEAR EXCESSIVE BRUSH PRESSURE REDUCE BRUSH PRESSURE (NARROWER TRACE)
F
LOOR VERY ABRASIVE
MAIN BRUSH NOISY MATERIAL WOUND AROUND BRUSH REMOVE
MAIN BRUSH DOES NOT TURN BRUSH DRIVING BELTS DAMAGED REPLACE BELT(S) DAMAGED
MAIN BRUSH AND SIDE BRUSH MOTORS DO NOT WORK MOTORS DAMAGED OR ITS CARBONS WEAR REPLACE MOTORS OR ITS CARBONS
FUSE BLOWN REPLACE
WASTE COMES OUT OF THE REFUSE CONTAINER REFUSE CONTAINER GASKET DAMAGED REPLACE
REFUSE CONTAINER TOO FULL EMPTY REFUSE CONTAINER
NEITHER FORWARD NOR REVERSE DRIVE WORK DRIVE MOTOR CABLES DISCONNECTED CHECK CONNECTIONS
DRIVE PEDAL FAULTY CHECK
MAIN CONTROL UNIT FAULTY CHECK
MAIN FUSE BLOWN REPLACE
BATTERIES DO NOT MAINTAIN THEIR CHARGE ELECTROLYTE LEVEL LOW TOP UP ELECTROLYTE LEVEL
BATTERY CELLS BURNED OUT REPLACE BATTERY
MOTOR OVER-LOADED CHECK MOTOR CURRENT ABSORPTION
BATTERY TERMINALS LOOSE CHECK AND TIGHTEN BATTERY TERMINALS
MATERIAL ENTANGLED IN MAIN BRUSH REMOVE
BEARINGS SEIZED REPLACE
EXCESSIVE BRUSH PRESSURE REDUCE BRUSH PRESSURE (NARROWER TRACE)
BATTERY DISCHARGES QUICKLY INSUFFICIENT CHARGE TIME INCREASE CHARGE TIME
BATTERY CELLS BURNED OUT REPLACE BATTERY
ELECTRIC SHAKER DOES NOT WORK RELAY FAULTY REPLACE
FUSE BLOWN REPLACE
EXCESSIVE MOTOR CONSUMPTION CAUSED BY:
- MOTOR CARBON BRUSHES WORN
- DIRTY OR WORN BEARINGS
- ARMATURE OR WINDINGS BURNED OUT
REPLACE
REPLACE
REPLACE
SHAKER MOTOR FUSE BLOWS EXCESSIVE SHAKER MOTOR CONSUMPTION (SEE ABOVE)
F
USE BLOWN REPLACE
CABLES DISCONNECTED OR SHORT-CIRCUIT CHECK OR REPAIR ELECTRIC SYSTEM
THE VACUUM ELECTRIC FAN DOES NOT WORK ELECTRIC FAN DAMAGED REPLACE
FUSE BLOWN REPLACE
CABLES DISCONNECTED OR SHORT-CIRCUIT CHECK OR REPAIR ELECTRIC SYSTEM
ENGLISH