26
To continue, press the button “NEXT”
On the tab "Sensor’s general options” you can see parameters of data exchange with an
external controller.
Meaning of parameters:
"Turn on a text format" - activates the data output in text format (takes effect when you click
"APPLY" and restart the sensor by power reset). By default is not activated.
"Turn on periodic issuance" - activates the periodic issuance of the data. By default is not
activated.
"Repeat Interval" - defines the repeat interval during periodic issuance in seconds.
"Turn on averaging "- activates averaging of the data.
«Exchange speed on UART» - allows you to install one of the seven proposed exchange
speeds.
«Device network address" - may have value from 0 to 255. Defines the network address of
the sensor. By default is 1. If the system uses several sensors, they must have unique
addresses, each of them must to be made individually for each sensor.
"Capacity" - the capacity of data that determine the fuel level.
To Next Page
Loading...
Need help?
General
