Realistic PRO-26 - Understanding Channel-Storage Banks

SEARCHING FOR AND TEMPORARILY
STORING ACTIVE FREQUENCIES
Limit Search
Limit search lets you search within a specific range of frequencies.
1 . Press PROG, then LIMIT. Lo appears on the display.
2. Enter the lower limit of the frequency range you want to search.
3. Press E/WX, then LilfflT. Hi appears on the display.
4. Enter the upper limit of the frequency range.
5. Press E/WX.
6. Press ▼ to search from the upper to the lower limit, or press A to
search from the lower to the upper limit. -L- appears.
7. When the scanner stops on a transmission, press MON to store
the frequency into the current monitor memory. Or, press A or ▼
to continue the search.
Note: You can halt the limit search by pressing limit. -H-
appears.
• Press A or T to step through the frequencies one at a time.
• Press MON to store the frequency into the current monitor
memory.
• Press UMIT to return to the limit search.
22
Direct Search
Direct search lets you search up or down from a frequency stored in a
channel.
1. Press MANUAL, enter the channel number, then press MANUAL
again to select the channel that has the frequency you want to
start searching from.
2. Press A or ▼ to search up or down from the selected frequency
-d- appears on the display.
3. When the scanner stops on a transmission, press MON to store
that frequency in the current monitor memory. Or, press A or ▼ to
continue the search.
Note: You can halt the direct search by pressing UMIT. -h- appears
on the display.
• Press A or ▼ to step through the frequencies one at a time.
• Press mon to store the frequency into the current monitor mem¬
ory,
• Press UMIT to return to the direct search.
23