Realistic PRO-26 - Operation.20; Turning on the Scanner; Setting Volume and Squelch.20; Storing Frequencies.20

OPERATION
TURNING ON THE SCANNER / SETTING
VOLUME AND SQUELCH
1. Rotate VOLUME V« turn clockwise to turn on the scanner.
2. Rotate SQUELCH fully counterclockwise.
3. Slowly turn SQUELCH clockwise until the hissing stops.
Note: To hear a weak or distant station, turn SQUELCH counterclock¬
wise. You might hear hissing, but you will not miss any transmissions.
STORING FREQUENCIES
You can store up to 200 frequencies into your scanner’s channels.
If you do not have a frequency reference for your area, use a limit or
direct search to find a transmission. See ‘Searching For and Tempo¬
rarily Storing Active Frequencies" on Page 22.
Follow these steps to manually store frequencies.
1. Press manual. Enter the channel number you want to program.
2. Press PROG, vm appears on the display.
3. Enter a frequency, ensuring you enter the decimal point
4. Press E to store the frequency.
20
Notes:
• If you make a mistake in Step 3, Error appears on the dis¬
play and the scanner sounds three beeps. Press clear, then
proceed again from Step 3.
• Your scanner rounds frequencies down to the next valid fre¬
quency. For example, if you enter 151.473, the scanner
accepts this as 151.470.
5. R epeat Steps 1-4 to program more channels.
Note: To program the next channel, repeat Steps 2-4.
21