Realistic PRO-26 - Searching and Storing Frequencies

LISTENING TO MONITOR MEMORIES
Once you have stored frequencies using a direct or limit search, you
can listen to monitor memories by pressing MANUAL, MON, and then
the number for the monitor memory you want to listen to.
MOVING A FREQUENCY FROM A MONITOR
MEMORY TO A CHANNEL
1. Press MANUAL.
2. Enter the number of the channel where you want to store the
monitor frequency, then press prog. PCM appears on the dis¬
play.
3. Press MON, then enter the monitor memory number that contains
the frequency you want to store. The selected channel number
flashes
4. Press E/WX. The scanner stores the frequency into the selected
channel.
USING THE KEYLOCK
Once you program your scanner, you can protect it from accidental
program changes by turning on the keylock feature. In this mode, only
the SCAN, MANUAL, and KEYLOCK keys function.
To turn on keylock, press and hold KEYLOCK until K/L appears on the
display.
To turn off keylock, press and hold KEYLOCK until K/L disappears.
SCANNING THE CHANNELS
To begin scanning the channels, press SCAN. The scanner scans
through all non-locked channels in the activated banks. (See “Locking
Out Channels’ and "Turning Channel-Storage Banks On and Off.”)
Note: If the scanner does not scan, be sure you have set squelch so
you do not hear the hissing sound between transmissions.
Locking Out Channels
You can increase the effective scanning speed by locking out channels
that have a continuous transmission, such as a weather channel.
To lock out a channel, manually select the channel then press S/S/L-
out so L/O appears on the display.
To remove the lock-out from a channel, manually select the channel
then press s/s/l-out so L/o disappears from the display.
To unlock all channels in selected banks, select the banks while the
scanner is scanning. Then press manual and hold 5/S/L-OUT until the
scanner beeps twice.
Notes:
• There must be at least one active channel in each bank. You can¬
not lock out all channels.
• You can manually select then review the channels you have
locked.
Follow these steps to manually select locked-out channels.
1. Press MANUAL.
2. Press SHIFT. SET appears on the display.
3. Press rvw. The next locked-out channel appears. Repeatedly
press RVW to see the locked-out channels in sequence.