Owners/Installation Manual – Controller v2 | Reclaim Energy
RECLAIMENERGY.COM.AU
25
APPLE APP
1. Installation
a) Go to the App Store on the iPhone and search for
“Reclaim Energy”.
b) Install the App and wait for installation to complete.
2. Launch App
a) On launching the App, the
following screen will be
displayed. Click Ok to launch
the QR Code scanner.
3. Scan QR Code
a) The prompt to launch the QR code scanner is
shown below. Click ‘Ok’ to proceed.
b) When prompted to allow the App to use the camera,
select ‘While using the App’.
c) Locate the QR code sticker from
the controller box and scan it in
the App.
• Once the controller
information is saved, the App
will connect to the controller
and load its data.
4. Home Screen
The Home screen consists of:
a) The active mode.
b) The current tank temperature.
c) The last 12 hours of temperature
and power usage data.
d) The heat pump status.
e) ‘Boost’ button to activate a
one-shot Boost.
5. Timers Screen
The ‘Timers’ screen consists of:
a) The active mode and other options, which can be
selected by scrolling the wheel.
b) The Start Time and Run Time for the selected mode.
c) The T-On and T-Off temperature for the selected
mode.
3
To Next Page
Loading...
Need help?
General