10
If the lathe is to be attached to a bench, spacers of at least 25
mm (1”) depth must be used at each end of the lathe to raise it
from the bench surface and allow for movement of the motor,
see Fig 8.6.
If the lathe is to be mounted to a stand, unless the mounting
plate of the stand allows movement of the motor, spacers must
also be used.
Please note: Use of the DML305/A Leg Stand is recommended.
When oriented correctly, the mounting plates of the
DML305/A allow for movement of the motor, eliminating the
need for spacers.
8. Assembly
Fig 8.6
Bench
Motor
Spacer Spacer
To Next Page
Loading...
