Record Power PT260 - Safety regulations for maintenance; Safety regulations for place of work

socket.
- Do not remove or interfere otherwise in safety devices such as covers, limit switches.
- While handling parts above your possibilities, ask for helps from a qualified person.
- It is not recommended to work on the machine during a storm.
Safety regulations for maintenance
Maintenance and repair must be performed by a qualified person. Do not do maintenance work
before you get acquainted with the instructions for maintenance thoroughly.
- Before you start to perform any maintenance work, always turn off the switch and pull out the
plug from supply socket. A possibility of accidental putting the machine into operation by
another person is thus avoided.
- Any maintenance work on electric parts of the equipment may be done by a qualified person
only.
- Even if the machine is stopped, the power supply is not disconnected. Always disconnect the
plug from supply socket.
- Do not clean the machine or its peripheral devices even if the machine is completely out of
operation, unless the plug has been disconnected from supply socket. Keep your fingers in a
distance from belts and belt pulleys.
- While replacing electrical parts of the equipment, turn off the switch and disconnect the plug
from supply socket. Faulty parts should be replaced only with products having the same
specifications as the original ones.
- Do not remove or interfere otherwise in safety devices such as covers, limit switches, and do not block
them mutually.
- Do not switch the machine on before all covers removed for the purposes of maintenance are
put in their places again.
- Always keep the maintenance area including the working place clean.
- Any maintenance work must be done by a qualified staff in accordance with the instructions
issued by the machine manufacturer.
- Read the instruction manual for maintenance men carefully and completely.
- For replacement of parts and necessary things, get in advance
those being identical with the original type and complying with standards.
- Use only specified kinds or lubricating oils and grease or those equivalent to them.
- If any belt in the set of belts used gets longer than the limit prescribed, replace the whole set
completely.
- Do not use compressed air to clean the machine or to remove chips.
- Always check the results while a responsible person is present.
Safety regulations for place of work
- Always ensure a sufficient working area and free access to the machine and peripheral
devices.
- Put tools and any other obstacles in the place designed for this purpose, in a distance from the
machine.
- Ensure sufficient lighting in the working area which will not create shadows or cause the
stroboscopic effect. For safe and quality work the hygienic standards specify the minimum