16 | Installation
TROUBLESHOOTING
There are no LEDs on at all...
This indicates that there is no battery connected to the output (BROWN cable) or that the battery
is not at a suitable voltage level to be charged AND the input (RED cable) if the Charger is not
connected.
1. Check the auxiliary battery is above 0.1 V
2. Check all wiring to the Charger and battery, particularly the ground (BLACK cable).
3. Check fuses are intact and properly connected.
If the problem is still evident please contact your local Auto-Electrician.
The 'Charge Profile' LED is flashing...
This indicates that either the output or input is not valid.
Specifically, an auxiliary battery, at a suitable voltage level to be charged, is connected to the output
of the Charger however there is currently no valid charging source OR a valid charging source is
available but the auxiliary battery is not at a suitable voltage level to be charged or is not connected.
1. Check that the vehicle (RED cable) is electrically connected. The vehicle (RED cable) should be
connected directly to the start battery positive terminal via an adequately rated fuse.
2. Check that the ground (BLACK cable) is connected to the auxiliary battery and chassis ground.
3. Disconnect any loads from the auxiliary battery and check if the auxiliary battery is above 0.1 V.
4. Check all wiring to the auxiliary battery, particularly the ground (BLACK cable).
5. Check fuses are intact and properly connected.
If the problem is still evident please see the relevant points below.
The BCDC is connected to the 'vehicle' but the vehicle LED is off...
This indicates that the required turn ON conditions for this source have not been met. With the
BLUE cable left unconnected, the voltage at the RED cable must be above 12.9 V for a 12 V
installation or above 25.8 V for a 24 V installation. With the BLUE cable connected to Ignition, the
Ignition must be on and the voltage at the RED cable must be above 12.0 V for a 12 V installation or
above 24.0 V for a 24 V installation.
1. Check that the vehicle is running.
2. Check the voltage on the RED cable is above the required turn ON threshold for your installation
(see Section 1.6 (page 9)).
3. Check all wiring to the start battery, particularly the ground (BLACK cable).
If the problem is still evident please contact your local Auto-Electrician.
To Next Page
Loading...
Need help?
General
