EasyManuals Logo
Home>Redarc>Battery Charger>BCDC1212T

Redarc BCDC1212T User Manual

Redarc BCDC1212T
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
4 | Warnings and Safety Instructions
CAUTION
1. The Battery Charger should not be used by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they are supervised
or have been instructed on how to use the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the Battery Charger.
2. Do NOT alter or disassemble the Battery Charger under any circumstances. All faulty units
must be returned to REDARC for repair. Incorrect handling or reassembly may result in a risk of
electric shock or fire and may void the unit warranty.
3. Only use the Battery Charger for charging Standard Automotive Lead Acid, Calcium Content,
Gel, AGM, SLI, Deep Cycle or Lithium Iron Phosphate type 12 V batteries.
4. Check the manufacturer’s data for your battery and ensure that the ‘Maximum’ voltage of
the profile you select does not exceed the manufacturer’s recommended maximum charging
voltage. If the ‘Maximum’ voltage is too high for your battery type, please select another
charging profile.
5. Check the manufacturer’s data for your battery and ensure that the ‘Continuous Current Rating’
of the charger does not exceed the manufacturer’s recommended maximum charging current.
6. When using the Battery Charger to charge a Lithium Iron Phosphate battery, only batteries that
feature an inbuilt battery management system featuring under and over voltage protection and
cell balancing are suitable.
7. The Battery Charger is not intended to supply power to a low voltage electrical system other
than to charge a battery.
8. Cable and fuse sizes are specified by various codes and standards which depend on the type
of vehicle the Battery Charger is installed into. Selecting the wrong cable or fuse size could
result in harm to the installer or user and/or damage to the Battery Charger or other equipment
installed in the system. The installer is responsible for ensuring that the correct cable and fuse
sizes are used when installing this Battery Charger.
9. NEVER smoke or allow a spark or flame in vicinity of battery or engine. This may cause the
battery to explode.
PERSONAL SAFETY PRECAUTIONS
10. To assist with the safe operation and use of the Battery Charger when connected to the battery:
a. Wear complete eye protection and clothing protection. Avoid touching eyes while working
near a battery.
b. If battery acid contacts your skin or clothing, remove the affected clothing and wash the
affected area of your skin immediately with soap and water. If battery acid enters your eye,
immediately flood the eye with running cold water for at least 10 minutes and seek medical
assistance immediately.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Redarc BCDC1212T and is the answer not in the manual?

Redarc BCDC1212T Specifications

General IconGeneral
BrandRedarc
ModelBCDC1212T
CategoryBattery Charger
LanguageEnglish

Related product manuals